3
votes

- I make a few novelty products, at www.awkwardengineer.com. Sourcing an injection molder was a true challenge. I attended a tradeshow, www.d2p.com, and found that there were dozens of injection molders in the area, small businesses, that had absolutel

Author: Sam, 29.11.2012, 11:18
Idea status: under consideration

Response from the site administrator

makersrow, 04.12.2012
Hello! We just launched on October 24 and will be expanding into new categories and industries soon! Thanks for your feedback! We are very excited to expand into new industries too :)

Comments

Nobody commented on this idea

Leave a comment

Copyright - 2017 Informer Technologies, Inc. All Rights Reserved. Feedback system is used Idea.Informer.com